GE Healthcare · X-ray R&FPrecision
P500D It is very difficult and time consuming to trace back the Emergency Stop switch from the table for troub…
Precision 500D - It is very difficult and time consuming to trace back the Emergeny Stop switch from the table for troubleshooting.
Symptom
P500D It is very difficult and time consuming to trace back the Emergency Stop switch from the table for troubleshooting. Block diagrams provided are vague and do not give connector pin numbers.
Applies to
- Models
- Precision
- Product
- Precision 500D
- Component
- Emergency Stop Switch
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug
- Precision 500D Aurora, RCIM E-stop circuit is difficult to troubleshoot because there is no overall interconnect schematic from the RCIM operator console to the Corona 2 board in the System Cabinet.
- Precision 500D Aurora system with Magic PC.
- P500D Siemens Collimator lamp voltage adjustment instructions missing due to documentation issues.