GE Healthcare · Nuclear MedicineInfinia
Infinia / VG Table up down motion starts but front or back of table does not move, then gives error 167 max da…
Infinia / VG Table up down motion starts but front or back of table does not move, then gives error 167 max dac
Symptom
Infinia / VG Table up down motion starts but front or back of table does not move, then gives error 167 max dac
Error message
Error #167 (Error 167) MAXIMUM DAC COMMAND. AXIS = 9 HEIGHT (Table Up / Down)) Error #167 (Error 167) MAXIMUM DAC COMMAND. AXIS = 9 HEIGHT (Table Up / Down)
Applies to
- Models
- Infinia
- Product
- Infinia II Infinia II Acquisition System
- Component
- *Patient Table *Patient Table *Patient Table 5262751 Infinia/VG Table Flexible Couplings 5262751 Infinia/VG Table Flexible Couplings
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2
- After software upgrade FMI40786, the Infinia application does not automatically start on boot up
- I need the product data sheet on catalog E4500AK x-ray in use warning light interface control panel for Infinia
- Infinia Does not recognize collimator is mounted to detector, not reading collimator ID correctly.
- Where do I obtain the Non-Linear Correction tables for a VG/Infinia Hawkeye system if can't find the CD that came with the DAS assembly?
- Hawkeye CT scan Ring (Circular) artifacts in X-ray images appearing in the same radius in all of the images.