Infinia Scan stoppage occured indicating to the customer that there has been a Hardware communication error.
Symptom
Infinia Scan stoppage occured indicating to the customer that there has been a Hardware communication error. Scan stoppage will occur indicating to the customer that there has been a Hardware communication error. The error log will have the following error” FE_WRITE_PORT_ERROR:.:Hardware communication error:.:Try again Perform system reset.:.: Failed to write Front End port: ( Port: 0x0 on POP board):.:Trace:{1}” Infinia Scan stoppage occured indicating to the customer that there has been a Hardware communication error. The error log will have the following error” FE_WRITE_PORT_ERROR:.:Hardware communication error:.:Try again Perform system reset.:.: Failed to write Front End port: ( Port: 0x0 on POP board):.:Trace:{1}”
Error message
FE_WRITE_PORT_ERROR:.:Hardware communication error:.:Try again Perform system reset.:.: Failed to write Front End port: ( Port: 0x0 on POP board):.:Trace:{1
FE WRITE PORT ERROR:.:Hardware communication error:.:Try again Perform system reset.:.: Failed to write Front End port: ( Port: 0xa1e on DOC board of detector #1):.:Trace:{1} FE WRITE PORT ERROR:.:Hardware communication error:.:Try again Perform system reset.:.: Failed to write Front End port: ( Port: 0xa1e on DOC board of detector #1 ):.:Trace:{1}Applies to
- Models
- Infinia
- Product
- Infinia II Infinia II Acquisition System
- Software
- Infinia All Infinia All. Including Infina 1 and Infinia II. Infinia All. Including Infina 1 and Infinia II.
- Component
- 5252414 FOX POP BOARD (For New CDL) 5252414 FOX POP BOARD (For New CDL) PCA000526 > PCA000547> 5252414 *Gantry Gantry Gantry
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2
- After software upgrade FMI40786, the Infinia application does not automatically start on boot up
- I need the product data sheet on catalog E4500AK x-ray in use warning light interface control panel for Infinia
- Infinia Does not recognize collimator is mounted to detector, not reading collimator ID correctly.
- Where do I obtain the Non-Linear Correction tables for a VG/Infinia Hawkeye system if can't find the CD that came with the DAS assembly?
- Hawkeye CT scan Ring (Circular) artifacts in X-ray images appearing in the same radius in all of the images.