GE Healthcare · X-ray R&FRevolution
Revolution XRd Wallstand Hand Control Board burned up upon powerup.
Revolution XRd Wallstand I/O board diagnostics fails
Symptom
Revolution XRd Wallstand Hand Control Board burned up upon powerup. While running diagnostics on the Wall Stand I/O board WLS A2 A1 A2, the 10 volt reference test reported reading 6.6 volts. The 10 volt reference was measured to be 10.0 volts.
Applies to
- Models
- Revolution
- Product
- Revolution XRd
- Component
- Wallstand (Thunder)
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- Revolution XR/d After a Load From Cold, the AWS exhibits strange operation and the SUIF does not have any Positioner Configuration and Calibration selections due to the use of the incorrect Jumpstart…
- Revolution XRd2X Worklist query on "All Systems in this Modality" does not retrieve anything after FMI 10791A is completed due to the default query set to DX.
- Revolution XR/d error 4280 when trying to make exposure to table or wallstand detector
- Revolution XRd 2X The HP Workstation reboots itself.
- Def8000, Def5000, Revolution XRd and XRD2X Latent lead marker image burned into the detector.