GE Healthcare · X-ray R&FPrecision
P500D Cannot access the MITRA service GUI directly to view the Dicom configuration parameters.
Precision 500D Mitra GUI direct access
Symptom
P500D Cannot access the MITRA service GUI directly to view the Dicom configuration parameters. There is no procedure in the service manual to access the MITRA service GUI directly because the system was designed to provide access via the IUI Console SUIF screens. This procedure is necessary to obtain direct access to the DICOM Configuration parameters.
Applies to
- Models
- Precision
- Product
- Precision 500D
- Software
- All Versions
- Component
- P500D Saturn Digital Computer
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug
- Precision 500D Aurora, RCIM E-stop circuit is difficult to troubleshoot because there is no overall interconnect schematic from the RCIM operator console to the Corona 2 board in the System Cabinet.
- Precision 500D Aurora system with Magic PC.
- P500D Siemens Collimator lamp voltage adjustment instructions missing due to documentation issues.