GE Healthcare · CTHiSpeed
CTi system will not restore calibrations after the scan disk was replaced
Symptom
CTi system will not restore calibrations after the scan disk was replaced. The old Scan disk was a ST32272N. New one is an ST39216N. Inspection of the Disks shows the FE copied the old jumper settings from, the old one to the new one. CTi system will not restore calibrations after the scan disk was replaced. The old Scan disk was a ST32272N. New one is an ST39216N. Inspection of the Disks shows the FE copied the old jumper settings from, the old one to the new one.
Applies to
- Models
- HiSpeed
- Product
- HiSpeed CTi 6.X HiSpeed CTi 6.X with Octane and HSA Gantry HiSpeed CTi 6.X with Octane and HSA Gantry Links to the updated Product Service Manuals, FMIs, Service Notes, Option Manuals and Operator Documents can be found online at the attached sites. Always use the most appropriate documentation for your system.
- Area
- CT
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare CT issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare CT issues
- Scanner Hardware Stopped Scan
- Patient Schedule fails to display some patients when updated.
- Ring artifact on axial images with no errors in logs.
- Scanner Hardware Stopped Scan.
- Both gantry controls are flashing and scanning hardware reset failed with SGI Indigo Console, HiSpeed Advantage Gantry
- Center Smudge Artifact.