GE Healthcare · MR22522932252302
Unable to Run MCR Multi coil Receive Chain Tool
Unable to Run MCR Tool
Symptom
Unable to Run MCR Multi coil Receive Chain Tool
Error message
2252293 The Driver Module Has Detected a Fault. Wed Apr 21 20:00:24 2004 Error: 2252293 Host: lx-mr Process: NSP File: SCP:DCB Line: 1986 The Driver Module Has Detected a Fault.^A Details of the Fault can be found in other error messages.-> 2252302 Multicoil Bias Fault Detected - Transmit Fault 2252302 IC_OPEN_SG NSP SCP:DCB 793 Multicoil Bias Fault Detected - Transmit Fault. Try re-seating all coil connectors. MCD1 Channel 5 of 16, counting from 1 Value: -2 mA Limit: 0 mA Mask of failed channels: 0x10 Ch 1-8 : Legacy MC Conn Ch 17-24 : Conn A Ch 25-32 : Conn B-> analyze_signal failed! Could not find image file. Please scan again. Operator message, not logged in error log. analyze_signal failed! Could not find image file. Please scan again.
Applies to
- Product
- Open Speed with EXCITE For HFO4 and HFO5 only
- Software
- OPENMR4-HFO4 Software version for HFO4 system, which is OpenSpeed with Excite Technology
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Multicoil Bias Fault errors on multiple coils.
- Multicoil Receiver Test Tool Analysis Failure.
- 2252302 Multicoil Bias Fault due to defective coil cable
- Driver Module Errors Due to the MRID 1.5T 8 Channel NV Array Coil.
- Cannot scan in Head Transmit Mode due to TR Driver Faults due to 1.5T LINEAR EXTREMITY CBL With COIL ID.
- Open Circuit due to Loose Hardware in Coil Cable's Hypertronics Connector.