GE Healthcare · Nuclear MedicineInfinia2411012
Infinia II Automatic Bed Height Calibration (Auto LINDEF) does not work in M4 2.004.004.1 software Infinia II…
Infinia II Automatic Bed Height Calibration (Auto LINDEF) does not work in M4 2.004.004.1 software
Symptom
Infinia II Automatic Bed Height Calibration (Auto LINDEF) does not work in M4 2.004.004.1 software Infinia II System Service Manual Direction 2411012-100 Rev. 4 Page 6-15 Motion Axes Calibration section 6.1.1.5 Automatic Bed Height Calibration
Applies to
- Models
- Infinia
- Product
- Infinia II Infinia II Acquisition System
- Software
- Infinia 2.004.004.1 Infinia 2.004.004.1 Infinia 2.004.004.1 - Infinia II Software Acquisition Package M4 + Patch
- Component
- *Patient Table *Patient Table *Patient Table
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2
- After software upgrade FMI40786, the Infinia application does not automatically start on boot up
- I need the product data sheet on catalog E4500AK x-ray in use warning light interface control panel for Infinia
- Infinia Does not recognize collimator is mounted to detector, not reading collimator ID correctly.
- Where do I obtain the Non-Linear Correction tables for a VG/Infinia Hawkeye system if can't find the CD that came with the DAS assembly?
- Hawkeye CT scan Ring (Circular) artifacts in X-ray images appearing in the same radius in all of the images.