GE Healthcare · MR2248602
Unable to Scan after Installing the Jumper into J2 of the PDU Control Board which Allowed the PDU To Power On
Symptom
Unable to Scan after Installing the Jumper into J2 of the PDU Control Board which Allowed the PDU To Power On Cannot turn on Gradients or RF amp. PDU had 480vac incoming power but EMO reset button was not active. In the back of the PDU is a board called PCBA that needs 12vdc in order to activate some relays, which allow the EMO button to be active.
Error message
2248602 PDU in Stop Mode. Emergency Stop button was pressed or PDU 24 Volt supply has failed. 2248602 PDU is in Stop mode. Emergency Stop button was pressed or PDU 24 Volt supply has failed.
Applies to
- Product
- Open Speed with EXCITE For HFO4 and HFO5 only
- Software
- OPENMR4-HFO4 Software version for HFO4 system, which is OpenSpeed with Excite Technology
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Loose cable between WIM and SCIM.
- CWA ID101099. Power Glitch or e-stop Pressed by Accident
- CWA ID105421 PDU in Stop Mode and TPS Download failure.
- Accidental Push of E-stop Button.
- PDU in Stop Mode and TPS Download failure.
- CWA ID112495. No Power to the Table and Magnet Display, Table Will Not Move And No Lights On the Magnet.