Multicoil Bias Faults Due to Coil.

Symptom

Error message

2252301 Multicoil Bias Fault Detected - Open Circuit. Try re-seating all coil connectors. MCDx Channel x of y, counting from 1 Value x mA Limit y mA See Long Description for Extended Error 2252301 MRI_GB_OW0 NSP SCP:DCB 816 Multicoil Bias Fault Detected - Open Circuit. Try re-seating all coil connectors. MCD1 (or MCD2) Channel 1 of 16, counting from 1 Value: 2 mA Limit: 298 mA Mask of failed channels: 0x1 Ch 1-8 : Legacy MC Conn Ch 17-24 : Conn A Ch 25-32 : Conn B-> Extended Error: This fault was detected by the Driver Module. An open circuit fault occurs when the actual value is less than the pre-defined limit. Check system cables, connectors, coils and configurations. Re-seat all coil connectors. The mask of all failed channels indicates additional channels with the same fault - convert the hex number to a bitmap to decipher the mask, with channel 1 indicated by the least significant bit and channel 16 indicated by the most significant bit. For example, a mask of 0x3c converts to 0011 1100, meaning channels 3, 4, 5, and 6 all experienced the same failure. The key at the bottom of the error message shows the MC driver bias channels provided by the Driver Module used with each mult

Applies to

Models

Excite

Product

Excite Includes Excite 1 and Excite 2, 10.0, 11.0 and 11.1 Software.

Software

11.1 For product 1.5T Excite only. Note, 3T Excite goes with software G3, not 11.0 or 11.1.

Area

MR

Related GE Healthcare MR issues

• CWA How to Change Date or Time on LX, Excite, HD, HDe, HDx, HDxT, HFO, Excite HFO, Ovation1-4, Profile1-5, Discovery MR450 MR750 and Optima 450w Systems.
• CWA No Power to the Table and Magnet Display, Table Will Not Move And No Lights On the Magnet.
• CWA How to Change Exam Number from Remote Tools.
• Known Software issue with 15M4B coding error.
• Unable to Send Images to the PACS Due to PACS is down.
• U41 of the Slave RF Ctrl Assy, part of the PSU in the SRFD2 RF Amplifier Failed.