GE Healthcare · Nuclear MedicineInfinia
Gantry Error 157, GDU show Error 157 CLC OVERCURRENT axis = $
Symptom
Gantry Error 157, GDU show Error 157 CLC OVERCURRENT axis = $
Error message
Error #157 (Error 157) CLC OVERCURRENT axis = $
Applies to
- Models
- Infinia
- Product
- Infinia HE4 Infinia II Hawkeye 4 & Infinia II GP (Infinia running Windows XP software) Infinia II Infinia II Acquisition System Infinia I Infinia I Acquisition System
- Component
- 5176677 Infinia Driver 200V/15A for Table Up/Down, Radial 1 & 2 (and Lateral when Radials are disabled) 5176677 Infinia Driver 200V/15A for Table Up/Down, Radial 1 & 2 (and Lateral when Radials are disabled) High voltage motor driver 200V/15Amp, controls the following axes: Radial in/out Head #1, (or Lateral motion in L Mode) Radial in/out Head #2 Table Up/Down
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2
- After software upgrade FMI40786, the Infinia application does not automatically start on boot up
- I need the product data sheet on catalog E4500AK x-ray in use warning light interface control panel for Infinia
- Infinia Does not recognize collimator is mounted to detector, not reading collimator ID correctly.
- Where do I obtain the Non-Linear Correction tables for a VG/Infinia Hawkeye system if can't find the CD that came with the DAS assembly?
- Hawkeye CT scan Ring (Circular) artifacts in X-ray images appearing in the same radius in all of the images.