GE Healthcare · Nuclear MedicineInfinia
Infinia table moves vertically but then stops either at the top limit or the bottom limit with error #36
Symptom
Infinia table moves vertically but then stops either at the top limit or the bottom limit with error #36
Error message
Error # 36 (Error #36) ZERO SWITCH NOT FOUND, AXIS = HEIGHT (Axis 9)
Applies to
- Models
- Infinia
- Product
- Infinia HE4 Infinia II Hawkeye 4 & Infinia II GP (Infinia running Windows XP software) Infinia I Infinia I Acquisition System Infinia II Infinia II Acquisition System
- Component
- *Patient Table *Patient Table *Patient Table 2199429 Table up down microswitch assembly (CBL000236) 2199429 Table up down microswitch assembly (CBL000236) Part #: 2199429 Part Type: GP CONSUMABLES Part Weight: 0.24 LBR Repairable: No Returnable: No Hazardous Material: N Description: 475-3651-0606,PIN MICRO SW ASSEMBLY FRU: Yes Status: Orderable
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2
- After software upgrade FMI40786, the Infinia application does not automatically start on boot up
- I need the product data sheet on catalog E4500AK x-ray in use warning light interface control panel for Infinia
- Infinia Does not recognize collimator is mounted to detector, not reading collimator ID correctly.
- Where do I obtain the Non-Linear Correction tables for a VG/Infinia Hawkeye system if can't find the CD that came with the DAS assembly?
- Hawkeye CT scan Ring (Circular) artifacts in X-ray images appearing in the same radius in all of the images.