GE Healthcare · MRSigna
Unable to scan, Erbtec errors.
Symptom
Unable to scan with Erbtec errors
Error message
Erbtec12 Fault +100 Supply Unacceptable Erbtec 12 Fault: +100 supply unacceptable; problem could be on the Power Control Board, the Low Voltage Transformer, an AC Switching Module fuse or relay, a bad cable, or a component failure causing excessive loading (including tubes). Erbtec 51 Fault: +100 Volt Supply Run Failure Erbtec50 Fault +100 Volt Supply Soft Start Failure Erbtec 50 Fault: +100 volt supply soft-start failure; this early failure of the +100 volt supply is probably due to an excessive load by one of the tubes or a circuitry failure on the Power Control Board. It is also possible that a problem exists in the AC Switching Module relays or fuses; perhaps a failed Low Voltage Transformer (not very likely).
Applies to
- Models
- Signa
- Product
- Signa Horizon (5X Horizon) 5X Horizon systems
- Software
- 5.X
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- CWA How to Change Date or Time on LX, Excite, HD, HDe, HDx, HDxT, HFO, Excite HFO, Ovation1-4, Profile1-5, Discovery MR450 MR750 and Optima 450w Systems.
- CWA No Power to the Table and Magnet Display, Table Will Not Move And No Lights On the Magnet.
- CWA How to Change Exam Number from Remote Tools.
- Known Software issue with 15M4B coding error.
- Unable to Send Images to the PACS Due to PACS is down.
- U41 of the Slave RF Ctrl Assy, part of the PSU in the SRFD2 RF Amplifier Failed.