GE Healthcare · MRSignaExcite2244845

Current Distortion Faults Due to HFA CONTROL BOARD ASSEMBLY.

Symptom

System Will Not Scan With Gradient Amplifier Current Distortion Faults.

Error message

2244845 The GP reported mutliple Gradient Amplifier %Axis Current Distortion Faults. See Long Description Note: "mutliple" is a typo in the original error message in software. Error: 2244845 Host: MNSHGEMRRAD Process: NSP File: SCP:Grad Line: 2865 The GP reported mutliple Gradient Amplifier % Axis Current Distortion Faults. Extended Error: This is a generic fault message indicating that the Gradient Amplifiers are not accurately following the current command from the IPG/SRF. If other faults occurred concurrently, they will provide useful information to assist with troubleshooting. Else, swap the control cable between the GP and the failing Gradient Amplifier with the Gradient Amplifier on another axis (swap one end of the cable only). If the fault moves, replace the Gradient Amplifier or Gradient Amplifier Control Board (board can be swapped with another axis to isolate), or check the gradient coil. If the fault does not move, replace the GP

Applies to

Models
Signa, Excite
Product
Signa HDxT This product is for 1.5T Signa HDxT systems with 15.0 software and HDi systems with 15.0 software. This product is for 1.5T Signa HDxT systems with 15.0 software and HDi systems with 15.0 software.
Software
15.0 For Product Signa HDxT and HDi only. -- NOT to be used with HDe. -- For Product Signa HDxT and HDi only. -- NOT to be used with HDe. --
Component
2396050-2 HFA CONTROL BOARD ASSEMBLY
Area
MR

Full cause & step-by-step resolution

The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.

Start free trialSign in

7-day free trial · no credit card required

Related GE Healthcare MR issues