Unable to Scan With Multi Coil Bias Faults due to Driver Module.

Symptom

Error message

2252293 The Driver Module Has Detected a Fault. Wed Apr 21 20:00:24 2004 Error: 2252293 Host: lx-mr Process: NSP File: SCP:DCB Line: 1986 The Driver Module Has Detected a Fault.^A Details of the Fault can be found in other error messages.->

2252301 Multicoil Bias Fault Detected - Open Circuit. Try re-seating all coil connectors. MCDx Channel x of y, counting from 1 Value x mA Limit y mA See Long Description for Extended Error 2252301 MRI_GB_OW0 NSP SCP:DCB 816 Multicoil Bias Fault Detected - Open Circuit. Try re-seating all coil connectors. MCD1 (or MCD2) Channel 1 of 16, counting from 1 Value: 2 mA Limit: 298 mA Mask of failed channels: 0x1 Ch 1-8 : Legacy MC Conn Ch 17-24 : Conn A Ch 25-32 : Conn B-> Extended Error: This fault was detected by the Driver Module. An open circuit fault occurs when the actual value is less than the pre-defined limit. Check system cables, connectors, coils and configurations. Re-seat all coil connectors. The mask of all failed channels indicates additional channels with the same fault - convert the hex number to a bitmap to decipher the mask, with channel 1 indicated by the least significant bit and channel 16 indicated by the most significant bit. F

Applies to

Product

Open Speed with EXCITE For HFO4 and HFO5 only

Software

OPENMR5-HFO5 Open Speed with Excite Product

Component

2296100 DRIVER MODULE for Excite See Long Description Excite 1 and 2 only. 10.0 and 11.0 Systems. Not for Excite HD. Also used on OpenSpeed with Excite.

Area

MR

Related GE Healthcare MR issues

• Prescan Fails with T/R driver fault, head path open Errors Due to Intergrated Head Assembly (formerly Head TR Switch)
• T/R Driver Fault is Due to Broken Pin on 5 inch Round General Purpose Coil.
• Multicoil Bias Fault errors on multiple coils.
• Accidental Push of E-stop Button.
• Multicoil Receiver Test Tool Analysis Failure.
• Driver Module Errors Due to the MRID 1.5T 8 Channel NV Array Coil.