Multicoil Bias Faults Due to Coil.

Symptom

Error message

2249149 T/R driver fault, head path open. 2249149 Host: LDEX Process: NSP File: SCP:../TrDriverMdsHWO.cpp Line: 1286 T/R driver fault, head path open. Possibly a disconnected cable between the driver board and the head T/R network, or an open diode in the head T/R switch.

2252301 Multicoil Bias Fault Detected - Open Circuit. Try re-seating all coil connectors. MCDx Channel x of y, counting from 1 Value x mA Limit y mA See Long Description for Extended Error 2252301 MRI_GB_OW0 NSP SCP:DCB 816 Multicoil Bias Fault Detected - Open Circuit. Try re-seating all coil connectors. MCD1 (or MCD2) Channel 1 of 16, counting from 1 Value: 2 mA Limit: 298 mA Mask of failed channels: 0x1 Ch 1-8 : Legacy MC Conn Ch 17-24 : Conn A Ch 25-32 : Conn B-> Extended Error: This fault was detected by the Driver Module. An open circuit fault occurs when the actual value is less than the pre-defined limit. Check system cables, connectors, coils and configurations. Re-seat all coil connectors. The mask of all failed channels indicates additional channels with the same fault - convert the hex number to a bitmap to decipher the mask, with channel 1 indicated by the least significant bit and channel 16 indicate

Applies to

Product

Open Speed with EXCITE For HFO4 and HFO5 only

Software

OPENMR5-HFO5 Open Speed with Excite Product

Component

2264742-3 0.7T EXTREMITY COIL SMALL KNEE/FOOT

Area

MR

Related GE Healthcare MR issues

• Prescan Fails with T/R driver fault, head path open Errors Due to Intergrated Head Assembly (formerly Head TR Switch)
• T/R Driver Fault is Due to Broken Pin on 5 inch Round General Purpose Coil.
• Multicoil Bias Fault errors on multiple coils.
• Driver Module Errors Due to the MRID 1.5T 8 Channel NV Array Coil.
• Open Circuit due to Loose Hardware in Coil Cable's Hypertronics Connector.
• Multicoil Bias Fault Detected on Peripheral Vascular Coil Due to a Coil Segment Disconnected.