GE Healthcare · X-ray R&FRevolutionAdvantx
Error 1200901 when detector communications failure.:replace FCIB ,Part No. 2337735 - NWK
Symptom
XRD2X Error 1200901 when detector communications failure. The IDC will automatically reset. The customer will have a message “Wait 2 Minutes while system recovers”. This failure is normally seen on the Wallstand.
error: 4020 system can boot up, but Advantx console report 4020
Error message
IDC communication with Detector run IDC - Detector communication is failure. Check the FCIB output light: there is not light Error 4020 Communications error to the digital unit
Applies to
- Models
- Revolution, Advantx
- Product
- Revolution XRd2X
- Component
- the FCIB for INNOVA 4100's RTAC
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- Revolution XR/d After a Load From Cold, the AWS exhibits strange operation and the SUIF does not have any Positioner Configuration and Calibration selections due to the use of the incorrect Jumpstart…
- Revolution XRd2X Worklist query on "All Systems in this Modality" does not retrieve anything after FMI 10791A is completed due to the default query set to DX.
- Revolution XR/d error 4280 when trying to make exposure to table or wallstand detector
- Revolution XRd 2X The HP Workstation reboots itself.
- ADXE RFX/SFX Legacy popping noises during angulation SN 3715