GE Healthcare · X-ray R&FPrecision
FMI 10841 Implementation Issue:MUST use Teleservice 2.3 delivered with FMI kit and upgrade from 1.3x to 1.4x , then 1.5b…
FMI 10841 Implementation Issue:MUST use Teleservice 2.3 delivered with FMI kit and upgrade from 1.3x to 1.4x , then 1.5b.
Symptom
FMI10841 Implementation Issue
Error message
Error 201 or New Config Codes not found
Applies to
- Models
- Precision
- Product
- Precision RXi
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug
- Precision 500D Aurora, RCIM E-stop circuit is difficult to troubleshoot because there is no overall interconnect schematic from the RCIM operator console to the Corona 2 board in the System Cabinet.
- Precision 500D Aurora system with Magic PC.
- P500D Siemens Collimator lamp voltage adjustment instructions missing due to documentation issues.