GE Healthcare · X-ray R&FDefiniumPrecision
No KV Feedback on Anode side and KV imbalance fault when taking tube warmup or exposures
Symptom
No KV Feedback on Anode side and KV imbalance fault when taking tube warmup or exposures
Error message
60-0306 and 60-0319 See Long Description 60-0306 and 60-0319 No kvp feedback on anode side, kv measured is less than 12 kVp .5 milliseconds after exposure start on anode side only, and kV unbalanced detected. Detects that there is more than 12 kVp difference between anode and cathode
Applies to
- Models
- Definium, Precision
- Product
- Definium 8000 PROTEUS XRa Precision 500D
- Component
- JEDI Generator This generator is used on Proteus and Precision 500D systems.
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- AEC Backup Time message
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug
- Precision 500D Aurora, RCIM E-stop circuit is difficult to troubleshoot because there is no overall interconnect schematic from the RCIM operator console to the Corona 2 board in the System Cabinet.
- Precision 500D Aurora system with Magic PC.