GE Healthcare · X-ray R&FPrecision360010634000053600029360002490001205000011
Unit not powering up correctly getting Jedi can bus errors
Symptom
Unit not powering up correctly getting Jedi can bus errors
Error message
3600106 Time out while expecting CAN message from generator See Long Description for example of boot errors 3400005 The system is booting. 3600106 Time out while expecting CAN message from generator 3600029 XRTechMgr failed to get NotifyJediId from JEDI 3600024 Jedi Power Up Failure 9000120 System failed to complete boot 5000011 System Boot Failed: Timed Out waiting for boot to complete, the system has to be Reset 6600000 User timeout on Boot 5000047 System Boot Failed: Boot Timed out 3400000 Timeout has occurred during the boot of the system 9000035 System is not ready. Please reboot the system 5000041 System Boot Failed: Timed out waiting for startBootPhase from SysCntrl. 3600106 Time out while expecting CAN message from generator 3400013 The system is shutting down.
Applies to
- Models
- Precision
- Product
- Precision 500D
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug
- Precision 500D Aurora, RCIM E-stop circuit is difficult to troubleshoot because there is no overall interconnect schematic from the RCIM operator console to the Corona 2 board in the System Cabinet.
- Precision 500D Aurora system with Magic PC.
- P500D Siemens Collimator lamp voltage adjustment instructions missing due to documentation issues.