The operator press SET button on RCU to transition from L-mode to H-mode (or COLL EXCH mode).
Symptom
The operator press SET button on RCU to transition from L-mode to H-mode (or COLL EXCH mode). The Lateral motion moves to minimum as normal and then all motions stop The GDU shows Idle - H-mode, but system is still in L-mode The operator press SET button on RCU to transition from L-mode to H-mode (or COLL EXCH mode). The Lateral motion moves to minimum as normal and then all motions stop. No error message displayed. The GDU shows Idle - H-mode, but system is still in L-mode. The position for Lateral shows 0.1 (should be 0.0 at this position).
Applies to
- Models
- Infinia
- Product
- Infinia II Infinia II Acquisition System
- Component
- *Gantry Gantry Gantry
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2
- After software upgrade FMI40786, the Infinia application does not automatically start on boot up
- I need the product data sheet on catalog E4500AK x-ray in use warning light interface control panel for Infinia
- Infinia Does not recognize collimator is mounted to detector, not reading collimator ID correctly.
- Where do I obtain the Non-Linear Correction tables for a VG/Infinia Hawkeye system if can't find the CD that came with the DAS assembly?
- Hawkeye CT scan Ring (Circular) artifacts in X-ray images appearing in the same radius in all of the images.