GE Healthcare · Nuclear MedicineInfinia

Can not perform Iter calibration on Infinia I station after changing computer platform to the XW4600 with FMI 40814A

Symptom

Can not perform Iter calibration on Infinia I station after changing computer platform to the XW4600 with FMI 40814A Iter calibration worked fine on the origional XW4000 computer platform Can not perform Iter calibration on Infinia I station after changing computer platform to the XW4600 with FMI 40814A

Applies to

Models
Infinia
Product
Infinia I Infinia I Acquisition System
Software
Infinia 1.004.009.25 Infinia 1.004.009.25 Infinia 1.004.009.25 See SN43623 SW 1.004.009.25 Acceptor Connector Patch, Rev. Prerequisite: Software version 1.004.009.21 (M4 FMI) must be installed Furnished Materials - 5165361 Software kit 1.004.009.21 Infinia I Software - Only used if not yet installed 1.004.009.23 MWL patch 1.004.009.25 Acceptor Connector Patch Important: If the SW you are running is 1.004.009.21 SW continue with the 1.004.009.23 MWL patchinstallation, and then with the 1.004.009.25 Acceptor connector.- using the instructions in this document. Infinia 1.004.009.21 Infinia M4 version is 1.004.009.21 Infinia M4 version is 1.004.009.21
Area
Nuclear Medicine

Full cause & step-by-step resolution

The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.

Start free trialSign in

7-day free trial · no credit card required

Related GE Healthcare Nuclear Medicine issues