HiSpeed Advantage RP/S
Symptom
How to add a default network route or static network route address to a system. A site may require a default route and/or a static route set up on the system when it is necessary for the CT system to network images to remote host(s) that is not located within the local sub-net that the CT resides on. While there can only be one "Default Route" defined on the CT system, there can be many "Static Routes" defined as necessary. Static Routes are limited network routes specified for a particular IP address or a range of IP addresses. In the event that there is no static route defined for a given address or range of addresses (and the address is not in the local sub-net), the Default Route will be the one that is used. If there are no static routes defined, the Default Route would be the only route out of the subnet.
Applies to
- Models
- HiSpeed
- Product
- HiSpeed Advantage RP/S HISPEED ADVANTAGE RP SOFTWARE LFC TAPE Version: rp25.5 Created: Tue Jan 26 09:23:55 CST 1999 Copyright: (c) 1988, 1999 The General Electric Company HISPEED ADVANTAGE RP SOFTWARE LFC TAPE Version: rp25.5 Created: Tue Jan 26 09:23:55 CST 1999 Copyright: (c) 1988, 1999 The General Electric Company Links to the updated Product Service Manuals, FMIs, Service Notes, Option Manuals and Operator Documents can be found online at the attached sites. Always use the most appropriate documentation for your system.
- Area
- CT
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare CT issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required