GE Healthcare · X-ray R&FPrecision110012838001061100124
Precision 500D Errors 1100128, 1100124, and 3800106 on boot up The system will not boot correctly, getting err…
Precision 500D Errors 1100128, 1100124, and 3800106 on boot up
Symptom
Precision 500D Errors 1100128, 1100124, and 3800106 on boot up The system will not boot correctly, getting errors 1100128, 1100124,and 3800106 on power up and the system will not allow fluoro.
Error message
1100128 Failed to create OCB Driver During boot, the Optics Control Board driver failed to initialize 3800106 Failed to read config parameter. 1100124 P500D Error
Applies to
- Models
- Precision
- Product
- Precision 500D
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug
- Precision 500D Aurora, RCIM E-stop circuit is difficult to troubleshoot because there is no overall interconnect schematic from the RCIM operator console to the Corona 2 board in the System Cabinet.
- Precision 500D Aurora system with Magic PC.
- P500D Siemens Collimator lamp voltage adjustment instructions missing due to documentation issues.