GE Healthcare · X-ray R&FPrecision2178938
Are the two versions of the P500D 32cm Image Intensifier Power Supplies interchangeable?
Symptom
Are the two versions of the P500D 32cm Image Intensifier Power Supplies interchangeable? Precision 500D 32 cm Image Intensifier Power Supply 2178938 . The original model number of this power supply was TH7195-4. When a replacement is ordered from GRPS, model number TH7195B-4 is being shipped. The new power supply does not have dip switches as the old one. Are the two parts Interchangeable? See Attachement for pictures of the original and replacement power supplies.
Applies to
- Models
- Precision
- Product
- Precision 500D
- Component
- Precision 500D 32 cm Image Intensifier High Voltage Power supply 2178938, model TH7195-4 and TH7195B-4. 32 cm Image Intensifier
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug
- Precision 500D Aurora, RCIM E-stop circuit is difficult to troubleshoot because there is no overall interconnect schematic from the RCIM operator console to the Corona 2 board in the System Cabinet.
- Precision 500D Aurora system with Magic PC.
- P500D Siemens Collimator lamp voltage adjustment instructions missing due to documentation issues.