Precision 500D Aurora system No Fluoro Exposure, no image on the fluoro monitor Precision 500D Aurora system N…
Precision 500D Aurora system No Fluoro Exposure, no image on the fluoro monitor due to the RT bus cable.
Symptom
Precision 500D Aurora system No Fluoro Exposure, no image on the fluoro monitor Precision 500D Aurora system No Fluoro Exposure. Digital record and Rad Overhead tube functions are normal. When the fluoro exposure is initiated, there is no image on the fluoro monitor. The No Radiation message disappears from the Image Monitor and the image area is white. There is no exposure on lamp or exposure tone. No error codes are displayed. RT bus test passes the first time it is run with the exception of bits 6 and 7 (IUI driver-Digital receiver, bits 6and 7 not used). Precision 500D Aurora system No Fluoro Exposure. Digital record and Rad Overhead tube functions are normal. When the fluoro exposure is initiated, there is no image on the fluoro monitor. The No Radiation message disappears from the Image Monitor and the image area is white. There is no exposure on lamp or exposure tone. No error codes are displayed. RT bus test passes the first time it is run with the exception of bits 6 and 7 (IUI driver-Digital receiver, bits 6and 7 not used).
Error message
No error is displayed
Applies to
- Models
- Precision
- Software
- Aurora
- Component
- RCIM RT BUS Cable used on Precision 500D Aurora System
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug
- Precision 500D Aurora, RCIM E-stop circuit is difficult to troubleshoot because there is no overall interconnect schematic from the RCIM operator console to the Corona 2 board in the System Cabinet.
- Precision 500D Aurora system with Magic PC.
- P500D Siemens Collimator lamp voltage adjustment instructions missing due to documentation issues.