Infinia/VG table is all the way down and has activated the second limit switch, getting error 153 on table hei…
Infinia/VG table is all the way down and has activated the second limit switch, getting error 153 on table height axis 9
Symptom
Infinia/VG table is all the way down and has activated the second limit switch, getting error 153 on table height axis 9 PSDB is a field based practical troubleshooting and experience tool, it is not an engineering substitute. PSDB should not replace your service training and engineering procedures. PSDB should be used as a guide, not necessarily a final solution. Always verify your actual troubleshooting, service and repair activity. Infinia/VG table is all the way down and has activated the second limit switch, getting error 153 on table height axis 9 Note: May be related to Infinia Gantry Missed Target error 143 on axis 9 table height motion. Alos see KOID 75921 and 87473
Error message
Error #153 (Error 153) Second Limit Pressed. Axis = 9 HEIGHT
Applies to
- Models
- Infinia
- Product
- Infinia I Infinia I Acquisition System Infinia HE4 Infinia II Hawkeye 4 & Infinia II GP (Infinia running Windows XP software) Infinia II Infinia II Acquisition System
- Component
- HG83000008B Table Rear (Left) Actuator HG83000008B Table Rear (Left) Actuator (Infinia / VG) -- - Left Motorized Actuator - is the actuator located in rear of table assembly and the one that has limit switches and encoder attached to *Patient Table *Patient Table *Patient Table HG83000009B Table Front (Right) Actuator HG83000009B Table Front (Right) Actuator (Infinia / VG) -- Right Motorized Actuator - is the actuator located closest to the detectors or what I would call the front of the table assembly
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2
- After software upgrade FMI40786, the Infinia application does not automatically start on boot up
- I need the product data sheet on catalog E4500AK x-ray in use warning light interface control panel for Infinia
- Infinia Does not recognize collimator is mounted to detector, not reading collimator ID correctly.
- Where do I obtain the Non-Linear Correction tables for a VG/Infinia Hawkeye system if can't find the CD that came with the DAS assembly?
- Hawkeye CT scan Ring (Circular) artifacts in X-ray images appearing in the same radius in all of the images.