MPi Intermittent loss of radiographic spot exposure, resulting in blank spot images (black or white depending…
Precision MPi Intermittent loss of radiographic spot exposure, resulting in blank spot images (black or white depending on doc pref) on INFIMED digital acquisition system.
Symptom
MPi Intermittent loss of radiographic spot exposure, resulting in blank spot images (black or white depending on doc pref) on INFIMED digital acquisition system. There is no xray being produced during digital spots. Fluoro functionality was not impacted by the failure. Fault isolation was difficult as there had been no errors reported to the operator or the local FE. System would fail for periods varying from minutes to hours in duration.
Error message
MPi Error 21
Applies to
- Models
- Precision
- Product
- Precision MPI Precision RXi
- Software
- CPI Eprom :738960 Rev D Power 7900 Platinum One Software version: 2005.01.25.09
- Component
- CPI Generator
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug
- Precision 500D Aurora, RCIM E-stop circuit is difficult to troubleshoot because there is no overall interconnect schematic from the RCIM operator console to the Corona 2 board in the System Cabinet.
- Precision 500D Aurora system with Magic PC.
- P500D Siemens Collimator lamp voltage adjustment instructions missing due to documentation issues.