LightSpeed 4.X - GRE
Symptom
"Scanner Hardware Stopped Scan" message appears in the operator console area during Helical Scan Scanner Hardware Stopped Scan message appears in the operator console area during Helical Scan Error: Error: 186218 XG Error and detail error code: 110 - 0904H Thermal error: HEMIT Thermal error Problem is consistent Problem started as intermittent; after shutting down software and cycling power to the Gantry and console scanning proceeds normally. The problem became increasingly worse and after 2 weeks would happen very frequent. [insite@erct ~]$ /usr/g/insite/bin/viewlog Sun Aug 29 11:03:41 2004 Error: 186218 Host: IRIS Process: tgp out File: tgp in input.c Line: 334 XG Error phase is 2 code is 110. Detail error code : 110 - 0904H Thermal error : HEMIT Thermal error
Error message
Error: 260006831 Axial Motor Control (AMC) logic detected GANTRY CONTACT switch FAULT during Rotation of the Gantry. See LD for complete error Sat Jan 1 16:17:39 2005 260006831 2 STC Axial amc isr.c 789 Function: AXIAL CONTROL : axial control Scan: 10821/2/1 Type: Helical Exception Level: Pri/Most Severe Time: 16:17:39:370 Log Series: 849 Axial Motor Control (AMC) logic detected GANTRY CONTACT switch FAULT during Rotation of the Gantry. CALL Service - Emergency Stop of the Axial Drive. (AMC State:8 Cmd:0x15b30008 CurVel:811 (.001 sec/rev)).
Applies to
- Models
- LightSpeed
- Product
- LightSpeed 4.X - GRE See Long Description for detailed information - H2_P_M16 Product Name: LightSpeed 4.X with GRE Product Photographs GE HEALTHCARE Method of remote or software identification - See attachment below for a complete list of software commands and typical results 1. check_config 2 . swhwinfo “swhwinfo” will have the following switches: · -c or -classc = Outputs the Class C version, if installed, on the system · -m or -classm = Outputs the Class M version, if installed, on the system · -o or -os = Outputs the Operating System version installed on the system · -da or -date = Outputs the date and time the software was installed on the system (LFC) -h or –help = Outputs complete details about all the available switches associated with swhwinfo swhwinfo –c –m –o -da List of Supported Console types: GOC3 (GRE) GOC4 (GRE) List of software the product can run: 07MW11.10 SP2.0, SP3.0, SP3.1 FAQ's Table weight limit - 180 kg (400 lbs) normal operation - 205 kg (450 lbs) maximum allowed with decreased accuracy Tube type - D3186T D3186T(green) Current production - M4 Options - TBD Links to the updated Product Service Manuals, FMIs, Service Notes, Option Manuals and Operator Documents can be found online at the attached sites. Always use the most appropriate documentation for your system.
- Area
- CT
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare CT issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required