GE Healthcare · Nuclear MedicineInfinia
Infinia will not reset gantry, scan setup get error message cannot start sequence.
Symptom
Infinia will not reset gantry, scan setup get error message cannot start sequence. Getting error 8 after repowering. User message when scan setup failed- ERROR SEQUENCE INIT:.:Failed to init the sequence:.:No user:.: Failed to init the sequence:.:Trace:Caused by:Failed to init the sequence Failed to Setup Failed to apply parameters to the scanner.WarmUp Failed to perform a subsystem: 'gantry' get properties for : 'PORT ACCESS' Can't use serial connection please check the cable connection or check the right COM port
Error message
Error #8 (Error 8) FAILURE: xilinx was not initialized
Applies to
- Models
- Infinia
- Product
- Infinia II Infinia II Acquisition System
- Component
- *Gantry Gantry Gantry
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2
- After software upgrade FMI40786, the Infinia application does not automatically start on boot up
- I need the product data sheet on catalog E4500AK x-ray in use warning light interface control panel for Infinia
- Infinia Does not recognize collimator is mounted to detector, not reading collimator ID correctly.
- Where do I obtain the Non-Linear Correction tables for a VG/Infinia Hawkeye system if can't find the CD that came with the DAS assembly?
- Hawkeye CT scan Ring (Circular) artifacts in X-ray images appearing in the same radius in all of the images.