GE Healthcare · X-ray R&FPrecision
Precision MPi Error E032 when trying to complete the heating calibration FE getting error E032 during the heat…
Precision MPi Error E032 when trying to complete the heating calibration
Symptom
Precision MPi Error E032 when trying to complete the heating calibration FE getting error E032 during the heating calibration. FE enters calibration and completes the small spot calibration, waits 10 minutes for tube cooling, then tries to calibrate the large but gets no exposure and error E032. Same thing happens if the FE tries to calibrate the large first, the large calibration completes then E032 when trying to calibrate the small.
Error message
CPI generator E032 CONSOLE COMM ERR Generator has detected error in communication with the console.
Applies to
- Models
- Precision
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug
- Precision 500D Aurora, RCIM E-stop circuit is difficult to troubleshoot because there is no overall interconnect schematic from the RCIM operator console to the Corona 2 board in the System Cabinet.
- Precision 500D Aurora system with Magic PC.
- P500D Siemens Collimator lamp voltage adjustment instructions missing due to documentation issues.