What is Philips CT error code ER2A?

Left control panel error. It is reported by the Operator Control Panel on Access Series CT (6/16/Dual) CT systems. Severity: Alarm — stator control board error condition; subsystem: Operator Control Panel.

What should a field engineer do about ER2A?

Check the left control panel's own Error Code display (Table 1-5) and cabling/CAN link to the Stator Control Board; refer to Table 1-5 'Control Panel Error Code' for the specific panel-side code.. Isolate the Operator Control Panel subsystem and follow the status-code troubleshooting in the service manual. FSELIB documents the full diagnosis and remedy for the Access Series CT (6/16/Dual).

Alarm — stator control board error conditionOperator Control Panel

ER2A — Left control panel error

Philips CT error code, reported by the Operator Control Panel.

What ER2A means

On Access Series CT (6/16/Dual) CT systems, status code ER2A indicates: Left control panel error. The code originates in the Operator Control Panel section of the Operator Control Panel. Severity level alarm (Alarm — stator control board error condition).

Reported action: Check the left control panel's own Error Code display (Table 1-5) and cabling/CAN link to the Stator Control Board; refer to Table 1-5 'Control Panel Error Code' for the specific panel-side code..

Listed in Table 1-3 'Stator Control Board Error Code vs System Error Code' of the Philips Access CT Service Trouble Shooting Guide (459800863401 Rev. C), for the Access Series CT (6/16/Dual) family. Not confirmed for other Philips CT systems.

Full troubleshooting for ER2A

The complete diagnosis, cause tree, and step-by-step remedy for the Operator Control Panel subsystem are documented in the FSELIB Activion16 (TSX-031A) service manual — re-authored, web-first, with real figures.

Open the Activion16 service manual

Related Operator Control Panel codes

PERRControl panel error PErr — the Control Panel CAN cable is mistakenly plugged into the Patient Table CAN port on the Gantry Interface Board CERRControl panel error CErr — the panel does not receive the signal from the UCOM ERR3Control panel error Err3 — patient Table Height error ERR4Control panel error Err4 — gantry Tilt Error ERR5Control panel error Err5 — the Communication between Panel and Stator Control Board time-out ERR6Control panel error Err6 — the Communication between Panel and Patient Table Motion control Board time-out ER2BRight control panel error N0CLeft control panel warning (grouped code)

Discuss ER2A with other field engineers in the FSELIB forum

Source: Philips Access CT Service Trouble Shooting Guide — 459800863401 Rev. C. Reference information re-authored by FSELIB — not a copy of the OEM manual.