GE Healthcare · Nuclear Medicine68040
During DST camera boot up system hangs on Last Check and Initialization then displays a Gantry Error 42
Symptom
During DST camera boot up system hangs on Last Check and Initialization then displays a Gantry Error 42 During DST camera boot up system hangs on Last check and initialization then displays a Gantry Error 42 Switch ON the camera and type: GO-APP (load binary) GO (Start application) The monitor will clear and system will start files check. At the line" Last check and Initialization", pop up windows appears with the following error message : Gantry Error 42 : Programmation error: Command to GDRIVE rejected
Error message
Gantry Error 42 : Programmation error : Command to GDRIVE rejected According trouble shooting manual, Gantry Error 42 means : GDRIVE Board may be seen on the bus but 68040 can't communicate with it. Usually a bad VMEXT1, VMEXT2 or GDRIVE Board. Swap these boards did not help
Applies to
- Product
- SMV DS Camera SMV DS Camera SMV DS Camera
- Software
- XT software XT software XT software
- Component
- *Software Software Software
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Nuclear Service Note Listing December 2010 (By Product)
- Service Note 43488_1 Aug/05 DST DST-XL and I-series Software Product Release XT 6.00 ACQ 8.1.3
- Service Note 43530_0 Jun/04 68040 CPU Battery Replacement
- Service Note 43429_4 Dec/09 MVME162 CPU Board Information
- Service Note 43416_0 Jun/03 MVME162 CPU Board Retrofit
- Nuclear Service Note Listing December 2010 (By Number)