GE Healthcare · MROptima22768022276804
Auto prescan fails due to P1 or P2 port was not connected properly to LPCA.Reseat the port P1 and P2 connector assemblie…
Auto prescan fails due to P1 or P2 port was not connected properly to LPCA.Reseat the port P1 and P2 connector assemblies into the emergency egress connectors inside the LPCA wqr.Optima MR450W.2276802…
Symptom
Auto and Manual Prescan Fails
Error message
2276802 Coil port connector(s) have been disconnected. Scanning is inhibited 2276802 ERROR: EM_RF_HUB_QUICK_DISCONNECT_FAULT Coil port connector(s) have been disconnected. Scanning is inhibited.\b\ Look in error log for detailed fault information. 2276802 Coil port connector(s) have been disconnected. Scanning is inhibited.\b\ Look in error log for detailed fault information. Extended Error: The RF Hub detected that one of the coil ports in the LPCA was disconnected. Specific errors are logged in other messages. Check the coil port cable connections at the RF Hub control board and at the LPCA. Re-seat the port P1 and P2 connector assemblies into the emergency egress connectors inside the LPCA. Run the Coil Datapath Diagnostic that utilizes the MCRv tool to isolate the problem. Possible cause(s): RF Hub Control Board 2276804 Coil port connector was disconnected. Scanning will be allowed when the port connector is reconnected. Connector: Port 1 and or 2 P1 P2 See Long Description for extended error. 2276804 Coil port connector was disconnected. Scanning will be allowed when the port connector is reconnected. Connector: Port 1 and or 2 P1 P2. Extended Error: The RF Hub detected that
Applies to
- Models
- Optima
- Product
- Optima MR450W Wide bore magnet. Not Discovery750 or Discovery450.
- Software
- DV22.0 For the Discovery MR750, MR450 or Optima MR450w products only. For the Discovery MR750, MR450 or Optima MR450w products only.
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- CWA ID100513. Will Not Scan with Gradient Errors.
- CWA ID103384. Computer Will Not Boot with the message on the screen that says Do Not Interact With System.
- CWA ID103582. Unable To Scan With Driver Module Errors.
- CWA ID104077. Computer Will Not Boot with the message on the screen that says Do Not Interact With System.
- IApplication Software does not complete the boot process with TPS Download failure Due to Idle Overnight With Power On.
- CWA ID107471. Unable to Download or Reset The TPS MGD or ISE.