GE Healthcare · MROptimaBrivo2252375
Diagnostic detected a DD Driver Fault High Voltage due to bad Hybrid Splitter
Symptom
Unable to Scan with Inductive or Direct Drive Bias Fault Unable to Scan with Inductive or Direct Drive Bias Fault. Sat Apr 23 10:21:22 2005 Error: 2225526 Host: lx-mr Process: NSP File: HPC_PORT_ID:spi_tr_mon Line: 6100 Inductive or Direct Drive fault, or Body TR switch fault due to impedance mismatch, path short Drive bias fault. Possibly a shorted diode in the driver switches, or a short circuit load.
Error message
2252375 Diagnostic detected a DD Driver Fault High Voltage Source of fault is DD (Direct Drive inside the Body Hybrid Assy Value 447 Limit 475 2252375 ERROR: EM_DCB_DIAG_DD_HIGH_VOLTAGE Diagnostic detected a DD Driver Fault - High Voltage. Source of Fault is %b. Value: %d V Limit: %d V Extended Error: Please refer to the troubleshooting documentation. Short-circuit load on affected DD line can cause this fault. Try unloading affected DD line. Try running the Driver Module Diagnostics, Power Supply Data. In HD/HDx Systems, BD1 is the Dynamic Disable Board at Front of Body Coil BD2 is the Dynamic Disable Board at Front of Body Coil BD3 is the Dynamic Disable Board at Back of Body Coil BD4 is the Dynamic Disable Board at Back of Body Coil
Applies to
- Models
- Optima, Brivo
- Product
- Optima MR360 Alias; HDsv. This concept covers both Optima MR360 and Brivo MR355. Both products are produced in Beijing, China.
- Software
- SV20.1 Applies to Optima MR360 and Brivo MR355, a.k.a. HDsv. Both products are made in Beijing, China.
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- CWA ID100513. Will Not Scan with Gradient Errors.
- CWA ID103384. Computer Will Not Boot with the message on the screen that says Do Not Interact With System.
- CWA ID103582. Unable To Scan With Driver Module Errors.
- CWA ID104077. Computer Will Not Boot with the message on the screen that says Do Not Interact With System.
- IApplication Software does not complete the boot process with TPS Download failure Due to Idle Overnight With Power On.
- CWA ID107471. Unable to Download or Reset The TPS MGD or ISE.