GE Healthcare · MROptimaBrivo
Unable to run MCR3 due to temporary service key which was shipped with the system.
Symptom
Unable to Launch the MCR3 Test from the Diagnostics Menu On the Optima360 or Brivo 355 scanner, Multi-coil Receive III test is found in Common Service Desktop>Diagnostics Tab>RF>Multi-coil Receive Diag.
Error message
PROCESSING ERROR! - Template dor "diagP_mcrReceive" not found in source XML document
Applies to
- Models
- Optima, Brivo
- Product
- Optima MR360 Alias; HDsv. This concept covers both Optima MR360 and Brivo MR355. Both products are produced in Beijing, China.
- Software
- SV20.1 Applies to Optima MR360 and Brivo MR355, a.k.a. HDsv. Both products are made in Beijing, China.
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- CWA ID100513. Will Not Scan with Gradient Errors.
- CWA ID103384. Computer Will Not Boot with the message on the screen that says Do Not Interact With System.
- CWA ID103582. Unable To Scan With Driver Module Errors.
- CWA ID104077. Computer Will Not Boot with the message on the screen that says Do Not Interact With System.
- IApplication Software does not complete the boot process with TPS Download failure Due to Idle Overnight With Power On.
- CWA ID107471. Unable to Download or Reset The TPS MGD or ISE.