GE Healthcare · MROptima
Appears the X and Y Coil Drive is swapped Error In DQA Calibration.
Symptom
Appears the X and Y Coil Drive is swapped Error In DQA Calibration see long description Auto DQA Calibration failed due to error during analysis. "Appears the X and Y Coil Drive is swapped". The images were correct geometrically. However the analysis reported detecting two objects. The top structure the program was measuring had a dip in it due to low fluid in the Phantom
Error message
X and Y Coil Drive is Swapped Appears as a message, not recorded in the error log.
Applies to
- Models
- Optima
- Product
- Optima MR450W Wide bore magnet. Not Discovery750 or Discovery450.
- Software
- 21.0 Only for Optima MR450W (wide bore) systems. (Not to be used on Discovery MR450 or Discovery MR750). Only for Optima MR450W (wide bore) systems. (Not to be used on Discovery MR450 or Discovery MR750).
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- CWA ID100513. Will Not Scan with Gradient Errors.
- CWA ID103384. Computer Will Not Boot with the message on the screen that says Do Not Interact With System.
- CWA ID103582. Unable To Scan With Driver Module Errors.
- CWA ID104077. Computer Will Not Boot with the message on the screen that says Do Not Interact With System.
- IApplication Software does not complete the boot process with TPS Download failure Due to Idle Overnight With Power On.
- CWA ID107471. Unable to Download or Reset The TPS MGD or ISE.