GE Healthcare · MROvation
Cannot find ETH2 following HP 9300 Replacement Due to Incorrect BIOS Setting for Ethernet Controller.
Symptom
Cannot find ETH2 following HP 9300 replacement The HP 9300 was being replaced for monitor going black. After swapping the hard drive into the new HP 9300 it failed to boot with cannot find eth2 in the bootup scroll. They could boot to applications but there was a popup that said "no correct ethernet device found". They could not access new patient.
Error message
No correct ethernet device found Popup message appears when booting up Applications.
Applies to
- Models
- Ovation
- Product
- Ovation with EXCITE
- Software
- OVATION5 Applies to Ovation5 (Excite) only. Ovation5 is 12.x platform software, not OvationHD.
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- CWA ID100060 Unable To Film.
- CWA ID100315. Auto and Manual Prescan Fails.
- What is the Acoustic Noise Level in the Ovation Magnet.
- Having Difficulties Setting Up Gradcal Scan From Dir 5112585 - Signa Ovation With Excite Technology
- CWA ID101091. Some or All Images in the Last Scan Did Not Reconstruct.
- HFO Cradle Will Not Move Due To Loss Of Home Flag Position.