GE Healthcare · Nuclear MedicineInfiniaXeleris
How to upgrade an Infinia I system to Infinia II.
Symptom
How to upgrade an Infinia I system to Infinia II.
Applies to
- Models
- Infinia, Xeleris
- Product
- Infinia I Infinia I Acquisition System
- Software
- Infinia 1.004.009.25 Infinia 1.004.009.25 Infinia 1.004.009.25 See SN43623 SW 1.004.009.25 Acceptor Connector Patch, Rev. Prerequisite: Software version 1.004.009.21 (M4 FMI) must be installed Furnished Materials - 5165361 Software kit 1.004.009.21 Infinia I Software - Only used if not yet installed 1.004.009.23 MWL patch 1.004.009.25 Acceptor Connector Patch Important: If the SW you are running is 1.004.009.21 SW continue with the 1.004.009.23 MWL patchinstallation, and then with the 1.004.009.25 Acceptor connector.- using the instructions in this document. Infinia 1.004.009.21 Infinia M4 version is 1.004.009.21 Infinia M4 version is 1.004.009.21
- Component
- *Gantry Gantry Gantry
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2
- Xeleris 1.1 DVD-RAMs do not always load back on to the same system that created them
- Unable to display or transfer Xeleris patient data.
- How to restore/install Entegra/Xeleris Aladdin protocols
- After software upgrade FMI40786, the Infinia application does not automatically start on boot up
- I need the product data sheet on catalog E4500AK x-ray in use warning light interface control panel for Infinia